Skip to content

CDL Hazardous Materials (HazMat): Bulk Packaging and Cargo Tanks Concepts

Importance ★★★☆☆ · 10% (estimate)

Based on 2026 exam standards

Overview

Bulk packaging is any large container such as a cargo tank, a portable tank or an intermediate bulk container. This chapter covers how these packages are marked and the extra care needed when product flows in or out of a tank. Expect questions about marking sizes, who must watch the tank, and the order of steps when you load or unload.

A cargo tank is built onto the truck and is filled and emptied right there. A portable tank comes off the vehicle to be filled or emptied and is then set back on for the trip. Bulk packages must show the product's identification number, which you find in the Hazardous Materials Table. Spec cargo tanks also carry retest date markings, while IBCs may skip the owner's name and shipping name. On a portable tank, the size of the tank decides how big the name letters are and on how many faces the number goes.

A qualified person has to watch the whole time a cargo tank is being loaded or unloaded. That person stays close, keeps the tank in view, knows the dangers and what to do in an emergency, and has the right and the skill to move the tank. Before the tank rolls, every manhole and valve gets closed, even for a small leftover amount.

Flammable liquids and compressed gases add their own steps. Keep the engine off unless it powers the pump. Ground the tank before you open a filling hole and leave the ground on until the hole is shut again. On a compressed gas tank, the liquid discharge valves stay closed except while product is moving.

Key concepts

  • Cargo tank

    Bulk packaging permanently fixed to a vehicle and loaded or unloaded while it stays on the truck. The MC306 is the usual one for liquids and the MC331 for gases.

    Memory tipBolted on, filled on the truck.

    Source: 49 CFR / NY DMV CDL-10 Section 9 · as of 2026

  • Portable tank

    Bulk packaging that is not fixed to the vehicle. Product goes in or out while the tank is off the truck, then the tank is put on for transport.

    Memory tipFill on the ground, haul on the truck.

  • Intermediate bulk container (IBC)

    A type of bulk package. It counts as bulk packaging, but it does not have to show the owner's name or the shipping name.

    Memory tipIBC: name markings can be left off.

  • Identification number display

    Bulk packages show the product's ID number from column 4 of the Hazardous Materials Table in black 100 mm (3.9 inch) figures on an orange panel, a placard, or a white diamond when no placard is needed.

    Memory tipColumn 4, black figures, 100 mm.

    Source: 49 CFR / NY DMV CDL-10 Section 9 · as of 2026

  • Tank watcher

    The qualified person who watches a cargo tank during loading or unloading. They must be alert, within 25 feet, with a clear view, know the hazards and emergency steps, and be allowed and able to move the tank.

    Memory tipClose, awake, and able to drive it away.

    Source: 49 CFR / NY DMV CDL-10 Section 9 · as of 2026

  • Grounding

    A required step when a cargo tank is filled with flammable liquid through an open filling hole. The ground goes on before the filling hole is opened and comes off only after the hole is closed.

    Memory tipGround first, unground last.

Bulk Packaging and Cargo Tanks: key points

  • Cargo tank = fixed to the vehicle; portable tank = loaded and unloaded off the vehicle
  • Most common cargo tanks: MC306 for liquids, MC331 for gases
  • ID numbers: Hazardous Materials Table column 4; black 100 mm (3.9 in) on orange panel, placard or white diamond
  • Portable tank shipping name: over 1,000 gal = 2-inch letters; under 1,000 gal = 1-inch letters
  • Portable tank ID number: 1,000 gal or more = each side and each end; ID hidden on truck = show it on the vehicle
  • Tank watcher: alert, clear view, within 25 ft, knows hazards and emergency steps, allowed and able to move the tank
  • Close every manhole and valve before moving any tank that is not empty
  • Flammable liquid: engine off unless it runs a pump; ground before the filling hole opens, until after it closes

Bulk Packaging and Cargo Tanks: common mistakes

  • Common mistake: If only a little product is left and the trip is short, I may move the tank with a valve open.

    What is correct: All manholes and valves are closed before the tank moves, whatever the amount or distance. Only a truly empty tank is exempt, which is why a small amount still counts.

  • Common mistake: When the engine runs the gas pump, I unhook the hose first and then shut off the engine.

    What is correct: The order is the other way around: turn the engine off after the transfer, then unhook the hose. Disconnect everything before the tank moves. It feels natural to put the hose away first, but the engine must stop first.

  • Common mistake: The person watching tank loading can be anywhere on the property, or within 100 feet.

    What is correct: The watcher must stay within 25 feet of the tank with a clear view of it. The 100-foot number belongs to attending a parked placarded vehicle, which is a different rule.

Bulk Packaging and Cargo Tanks: 10 sample questions

Practice questionReviewedCDL Hazardous Materials Test › Bulk Packaging and Cargo Tanks★★★★☆

Question 1. While a cargo tank is being loaded, how close must the person watching it be?

  1. ① Within 100 feet of the tank
  2. ② Anywhere on the property
  3. ③ Within 25 feet of the tank
▼ Show answer and explanation▲ Hide answer and explanation

Answer: ③ Within 25 feet of the tank

Key point: Tank loading watcher: within 25 feet

A qualified person must always watch cargo tank loading or unloading. That person must be alert, have a clear view of the tank, and be within 25 feet of the tank.

Wrong choices

  • Within 100 feet of the tank: 100 feet is the rule for attending a parked placarded vehicle, not for watching tank loading.
  • Anywhere on the property: The watcher must be close, alert and have a clear view of the tank.
Practice questionReviewedCDL Hazardous Materials Test › Bulk Packaging and Cargo Tanks★★★★☆

Question 2. A cargo tank has only a small amount of hazmat left and you are moving it a short distance. What must you do with manholes and valves first?

  1. ① Leave them open if the amount is small
  2. ② Close all of them
  3. ③ Close only the valves at the rear
▼ Show answer and explanation▲ Hide answer and explanation

Answer: ② Close all of them

Key point: Close all manholes and valves before moving

Close all manholes and valves before moving a tank of hazardous materials, no matter how small the amount or how short the distance. Moving a tank with open valves or covers is illegal unless it is empty.

Wrong choices

  • Leave them open if the amount is small: The amount does not matter. Close them before moving the tank.
  • Close only the valves at the rear: All manholes and valves must be closed, not some of them.
Practice questionReviewedCDL Hazardous Materials Test › Bulk Packaging and Cargo Tanks★★★☆☆

Question 3. What is a cargo tank?

  1. ① Bulk packaging that is permanently attached to a vehicle
  2. ② A tank that is lifted off the vehicle for loading
  3. ③ Any drum that holds more than one gallon
▼ Show answer and explanation▲ Hide answer and explanation

Answer: ① Bulk packaging that is permanently attached to a vehicle

Key point: Cargo tank = bulk packaging fixed to the vehicle

Cargo tanks are bulk packaging permanently attached to a vehicle. They stay on the vehicle while you load and unload them.

Wrong choices

  • A tank that is lifted off the vehicle for loading: That describes a portable tank. A cargo tank stays on the vehicle when loaded and unloaded.
  • Any drum that holds more than one gallon: A drum is not bulk packaging fixed to the vehicle.
Practice questionReviewedCDL Hazardous Materials Test › Bulk Packaging and Cargo Tanks★★★☆☆

Question 4. How is a portable tank different from a cargo tank?

  1. ① It is always smaller than a drum
  2. ② It is not permanently attached and is loaded or unloaded off the vehicle
  3. ③ It can only carry gases
▼ Show answer and explanation▲ Hide answer and explanation

Answer: ② It is not permanently attached and is loaded or unloaded off the vehicle

Key point: Portable tanks are filled and emptied off the truck

Portable tanks are bulk packaging that are not permanently attached to a vehicle. The product is loaded or unloaded while the tank is off the vehicle, then the tank is put on a vehicle to be moved.

Wrong choices

  • It is always smaller than a drum: Size is not the difference. A portable tank is bulk packaging.
  • It can only carry gases: The manual does not limit portable tanks to gases.
Practice questionReviewedCDL Hazardous Materials Test › Bulk Packaging and Cargo Tanks★★★☆☆

Question 5. How tall must the black identification numbers on an orange panel be?

  1. ① 1 inch
  2. ② 100 mm (3.9 inches)
  3. ③ 2 inches
▼ Show answer and explanation▲ Hide answer and explanation

Answer: ② 100 mm (3.9 inches)

Key point: Bulk ID numbers: black, 100 mm (3.9 in)

The rules call for black 100 mm (3.9 inch) numbers on orange panels, placards, or a white diamond background.

Wrong choices

  • 1 inch: One inch is a letter height for shipping names on small portable tanks, not for ID numbers.
  • 2 inches: Two inches is a letter height for shipping names on large portable tanks, not for ID numbers.
Practice questionReviewedCDL Hazardous Materials Test › Bulk Packaging and Cargo Tanks★★★☆☆

Question 6. When loading or unloading flammable liquids, when may your engine be running?

  1. ① Any time, to keep the batteries charged
  2. ② Only when it is needed to run a pump
  3. ③ Only in cold weather
▼ Show answer and explanation▲ Hide answer and explanation

Answer: ② Only when it is needed to run a pump

Key point: Flammable liquids: engine off unless running pump

Turn off your engine before loading or unloading flammable liquids. Only run it if needed to operate a pump.

Wrong choices

  • Any time, to keep the batteries charged: Turn the engine off unless it runs a pump.
  • Only in cold weather: Weather is not an exception. Only running a pump is.
Practice questionReviewedCDL Hazardous Materials Test › Bulk Packaging and Cargo Tanks★★★☆☆

Question 7. Besides being alert and close by, what else must the person watching cargo tank loading be able to do?

  1. ① Sign the shipping papers
  2. ② Speak to the shipper by radio
  3. ③ Be authorized and able to move the cargo tank
▼ Show answer and explanation▲ Hide answer and explanation

Answer: ③ Be authorized and able to move the cargo tank

Key point: Tank watcher must be able to move the tank

The watcher must be alert, have a clear view, be within 25 feet, know the hazards, know emergency procedures, and be authorized to move the cargo tank and able to do so.

Wrong choices

  • Sign the shipping papers: Signing papers is not one of the watcher's duties listed in the manual.
  • Speak to the shipper by radio: This is not on the list. The watcher must be able to move the tank.
Practice questionReviewedCDL Hazardous Materials Test › Bulk Packaging and Cargo Tanks★★★☆☆

Question 8. You will fill a cargo tank with a flammable liquid through an open filling hole. When should the tank be grounded?

  1. ① Before opening the filling hole, and kept grounded until after it is closed
  2. ② Right after the filling hole is opened
  3. ③ Only after filling is finished
▼ Show answer and explanation▲ Hide answer and explanation

Answer: ① Before opening the filling hole, and kept grounded until after it is closed

Key point: Ground before opening; keep until after closing

Ground a cargo tank correctly before filling it through an open filling hole:

  1. Ground the tank before opening the filling hole.
  2. Keep the ground on until after the filling hole is closed.

Wrong choices

  • Right after the filling hole is opened: Ground first. Opening the hole before grounding is the wrong order.
  • Only after filling is finished: The ground must be in place for the whole filling, from before opening to after closing.
Practice questionReviewedCDL Hazardous Materials Test › Bulk Packaging and Cargo Tanks★★★☆☆

Question 9. Your truck engine runs the pump used to deliver compressed gas. When the transfer is done, what is the correct order?

  1. ① Unhook the hose, then turn the engine off
  2. ② Turn the engine off, then unhook the hose
  3. ③ Leave the engine running and drive off once the hose is stowed
▼ Show answer and explanation▲ Hide answer and explanation

Answer: ② Turn the engine off, then unhook the hose

Key point: Engine off after transfer, before unhooking hose

Unless the engine runs a pump, keep it off when loading or unloading. If you use the engine, turn it off after product transfer, before you unhook the hose. Then unhook all connections before moving the tank.

Wrong choices

  • Unhook the hose, then turn the engine off: This reverses the order. The engine goes off first, after the transfer and before unhooking.
  • Leave the engine running and drive off once the hose is stowed: The engine must be turned off after the transfer, before the hose is unhooked.
Practice questionReviewedCDL Hazardous Materials Test › Bulk Packaging and Cargo Tanks★★★☆☆

Question 10. Which cargo tank does the manual name as the most common for liquids?

  1. ① MC331
  2. ② DOT Spec 110A
  3. ③ MC306
▼ Show answer and explanation▲ Hide answer and explanation

Answer: ③ MC306

Key point: MC306 for liquids, MC331 for gases

The most common cargo tanks are the MC306 for liquids and the MC331 for gases.

Wrong choices

  • MC331: The manual names MC331 as the most common tank for gases.
  • DOT Spec 110A: This is not the tank the manual names as the common liquid tank.

Test yourself.

Importance
★★★☆☆ (3 / 5)
Weight
About 3 of 30 CDL Hazardous Materials Test questions (10%)

AI-written · Verified · Written by AI. Only units that passed a separate AI check (re-reading facts and numbers) are published. Tell us if you find a mistake.